Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boral Fence Installation: The Austin Owner’s Guide
Boral fence installation in Austin typically runs $3,500 to $9,000 for a full panel and post replacement, and we stock Boral-compatible posts, rails, and panels on our trucks for most jobs. Most Austin homeowners call us after a hailstorm snapped a top rail, a gate post started leaning after heavy rain softened the clay soil, or the original installer set posts in concrete that cracked after our freeze-thaw cycles. You’ll usually see the failure before you hear it: a gate that scrapes the ground on one corner, panels that rattle in the wind, or posts that tilt a few degrees and keep going.
Before we get into specifics, know this: Sawyer Remodel Austin is an independent installer. We install and repair Boral fencing, but we’re not affiliated with Boral or the manufacturer directly. That means we’ll give you the straight answer on whether a part is worth fixing or replacing, because we don’t have a factory quota to hit.
Which Boral Models This Applies To
Boral fencing comes in a few distinct product lines, and the parts don’t always swap between them. The three you’ll find around Austin are the Stratford (traditional picket profile, most common in older Bouldin Creek and Hyde Park homes), the Founders series (wider panels, often used for front-yard fences in newer builds out near Mueller), and the Boardwalk line (flat, modern profile, popular in east Austin renovations).
Here’s the part most guides skip: Boral panels are sized to sit inside routed posts, and the post dimensions changed between manufacturing years. A fence built before 2015 often uses 5×5 posts with a 1-inch channel. Newer installs use 4×4 posts with a ¾-inch channel. If you try to slide a new panel into an old post and it drops through or won’t seat, you’re not crazy: it’s a spec change, and we carry aluminum shims to correct the fit so you don’t have to redig every post.
Check the sticker on the bottom rail or the inside face of the post cap. If that’s faded or gone, measure the channel width with a tape measure before you order anything. If you’d rather not crawl around with a flashlight, call us and we’ll identify it on site during the estimate. OEM Boral parts cost 20 to 30 percent more than quality aftermarket equivalents, and for structural posts we recommend OEM. For cosmetic panels and caps, the aftermarket options from third-party molders in Houston hold up just as well in our climate.
Styles & brands we work with
Signs Your Boral Fence Installation Is Failing
- Panels rattle or shift when the wind picks up. This happens when the channel inserts wear down or the panel was never seated tight against the post. In Austin’s spring thunderstorm season, that rattle means moisture is getting into the seams and accelerating breakdown.
- Gate post leans toward the latch side. The weight of the gate pulls the post over time, especially in Austin’s expansive clay soil. When the post moves even half an inch, the latch stops lining up and the gate starts binding.
- White residue or hairline cracks at the bottom rail. That’s mineral wicking from the soil, and it’s common in neighborhoods along the Barton Creek floodplain. Once the bottom rail starts absorbing that moisture, the panel loses structural strength and starts to sag in the middle.
- Post cap is loose or missing. Caps keep water out of the post core. Without them, rainwater pools inside, rusts any metal reinforcement, and freezes during Austin’s winter cold snaps, splitting the post from the inside.
- Fence line has visible waves or dips. This is usually multiple posts failing at once, often from poor concrete mix at the original install or tree roots pushing upward. You’ll see it most on long runs without gate breaks, like the back fence lines in Crestview.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Boral fence installation in Austin runs $3,500 to $9,000 for a typical residential project. The low end covers panel replacement on an existing sound post system with cosmetic fixes. The high end is a full tear-out and re-set of every post, new concrete footers, new rails, and all panels on a fence line of 100 feet or more with a walk gate.
| Scope | Austin Installed Price | Typical Timeline |
|---|---|---|
| Single panel replacement (post intact) | $350 – $700 | Same visit during other work |
| One post replacement with concrete reset | $450 – $900 | Half day |
| Gate replacement with new post and hardware | $900 – $2,000 | One day |
| Full fence replacement (50 – 75 linear feet) | $3,500 – $6,500 | 2 – 3 days |
| Full fence replacement (100+ linear feet with gates) | $6,000 – $9,000 | 4 – 5 days |
Every quote is a written, line-item price before any work starts. That means you know the panel cost, the post cost, the concrete cost, and the labor cost separately. No change orders, no “we found an issue” surprise at the end. Every Boral fence installation we do carries the 365-Day Done Right Promise: if it’s not right, we come back and fix it inside a year, no invoice. If the repair fails within that year, the second visit is free. Luca Romano signs off on every fence job personally before the crew wraps the site.
DIY or Call Us?
You can safely identify the problem, check the channel width, and confirm your Boral series without touching a single tool. What you shouldn’t do is pull a leaning post yourself. A concrete-set post holds lateral tension, and when it gives, it gives suddenly. We’ve seen posts snap and swing into property lines. Same goes for gate tension: the hardware under load can release violently if you unbolt the wrong hinge first. This isn’t scare talk; it’s the reason our crew wears steel-toe boots and barricades the work area before we demo anything.
If you want to save on the diagnostic fee, send us photos of the panel, the post cap area, and the gate hinge from three angles. We’ll tell you over the phone whether it’s a simple panel swap or a post reset. Then we’ll put the price in writing before anyone drives out. Call (409) 834-4854 and you’ll get a live person, not a voicemail tree.
FAQs
A properly installed Boral fence lasts 20 to 25 years in the Austin climate. The panels and rails are composite material that resists rot and termite damage far longer than cedar, but posts can fail earlier if they were set with insufficient concrete or in low spots that hold water after storms. We see the most post failures in the 8 to 12 year range on poorly installed systems.
Yes, and around 60 percent of our Boral fence calls end up being repairs, not replacements. If the posts are sound and the panels are intact, we can swap individual panels, reset a single gate post, or replace caps and hardware without touching the rest of the fence line. We’ll tell you if you’re in that repair window or if you’re chasing problems that will cost more patchwork than a clean redo. Call (409) 834-4854 and we’ll give you an honest read.
A single post or panel replacement is typically done in half a day. A full fence replacement of 100 linear feet with two gates takes four to five days from demo to final concrete cure. We schedule around Austin’s spring storm patterns as best we can; if rain risks compromising a concrete set, we’ll tell you and we’ll reschedule at no charge.
We keep posts, rails, panels, caps, and gate hardware in our Austin inventory truck. We also stock parts for KraftMaid cabinetry, and Cambria and Silestone countertop systems, if you’re mid-remodel and hitting multiple fronts. If your Boral series is older or uncommon, we order direct and have it in hand within three to five business days before the install date.
Written by Luca Romano, Owner, Sawyer Remodel Austin at Sawyer Remodel Austin, serving Austin and nearby areas.
Ready to get your fence standing straight again? Call (409) 834-4854 for a free estimate. Luca and the crew at Sawyer Remodel Austin will give you the written price before any work starts, and we’ll show up when we say we will. Measure twice, cut once, then we actually build the thing.
